1) Start pro/e setup
启动proe安装程序
2) Open license.dat with any  txt-editor and replace every occurance of 00-00-00-00-00-00 with your computer real HOST_D (same one shown in the bottom left corner of the Pro/e setup). Save the ptc_licfile.dat
用记事本打开license.dat然后用你自己电话的网卡号替换所有的00-00-00-00-00-00，注意不要带上任何的空格。然后保存
3) Install proe - proe_mech -ptc_distributed_services (optional). On license-config screen select "nodelocked license" and point to edited ptc_licfile.dat
安装proe(proe_mech,ptc_distributed_services这些是可选的，一般不用装），在许可配置对话框内选择“锁定的许可（nodelocked license)”然后选择你刚才生成的ptc_licfile.dat.
Next  apply a patches (if u didn't install the complete package, you will get "File not found" errors, accept or bleed)
下一不就是进行破解，如果你没有选择全部安装，有些会出现“文件没到File not found”错误，选择接受或跳过。
for pro/engineer:（对proe）
Copy "proe_WF5_" to folder <proeWildfire 5.0 progdir>\x86e_win64\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
复制"proe_WF5_" 到你的pro安装目录下的\x86e_win64\obj目录内，然后点击"Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"。
后面的步骤可以不用管。
for pro/mechanica
Copy "proe_mech_WF5_Win64_#" to folder <proe Wildfire 5.0 progdir>\mech\x86e_win64\obj and click "Next > OK > Next > OK > Next > OK > Next > OK > Finish > OK"
Copy "proe_mech_WF5_Win64_#" to folder <proe WF5 progdir>\mech\x86e_win64\ptc and click "Start > OK"
proe5.0安装方法
for ptc distributed services
Copy "ptc_distributed_services_WF5_" to folder <ptc_distributed_services WF5 Win64 progdir>\x86e_win64\obj and click "Next > OK > Finish > OK"
That's all.. Enjoy :)